A Comparison of Internal Mandrel Designs for Rotary Draw Bend Forming of Carbon-fibre/Thermoplastic (PA6) Tubular Structures

AbstractCarbon fibre reinforced thermoplastic tubular structures can be post-formed into desired curvatures via rotary draw bending (RDB) at elevated temperatures. During this process, a rigid internal mandrel is required to support the walls of the tubes to maintain their ovality and minimise unwanted geometrical distortions. This paper investigates four internal mandrel designs for post-forming carbon fiber reinforced polyamide 6 (CF/PA6) thermoplastic tubes. Mandrel designs include silicone rod, bullet, wire, and coil spring, were evaluated through RDB-forming experiments with [± 60°]4 CF/PA6 tubes formed to 90° bends. The designs were evaluated for their effectiveness on minimising distortions resulted from induced stresses during post-forming by measuring the post-formed tube diameter and extrados strains. The mandrel designs were also evaluated for their usability when integrated into the RDB process. Results from optical measurements and micro-computed tomography showed the spring mandrel outperformed others, producing tubes with the least geometrical distortions and no defects during the forming process. As compared to other designs, the spring mandrel is a reusable unibody design that is easy to assemble and remove from the tubes.