Enhanced Photoelectrochemical Performance Using Cobalt-Catalyst-Loaded PVD/RF-Engineered WO₃ Photoelectrodes

Critical to boosting photoelectrochemical (PEC) performance is improving visible light absorption, accelerating carrier separation, and reducing electron-hole pair recombination. In this investigation, the PVD/RF method was employed to fabricate WO3 thin films that were subsequently treated using the surface treatment process, and the film surface was modified by introducing varying concentrations of cobalt nanoparticles, a non-noble metal, as an effective Co catalyst. The results show that the impact of loaded cobalt nanoparticles on the film surface can explain the extended absorption spectrum of visible light, efficiently capturing photogenerated electrons. This leads to an increased concentration of charge carriers, promoting a faster rate of carrier separation and enhancing interface charge transfer efficiency. Compared with a pristine WO3 thin film photoanode, the photocurrent of the as-prepared Co/WO3 films shows a higher PEC activity, with more than a one-fold increase in photocurrent density from 1.020 mA/cm(2) to 1.485 mA/cm(2) under simulated solar radiation. The phase, crystallinity, and surface of the prepared films were analysed using X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and Raman spectroscopy. The PVD/RF method, scanning electron microscopy (FE-SEM), and high-resolution transmission electron microscopy (HR-TEM) were employed to assess the surface morphology of the fabricated film electrode. Optical properties were studied using UV-vis absorbance spectroscopy. Simultaneously, the photoelectrochemical properties of both films were evaluated using linear sweep voltammetry and electrochemical impedance spectroscopy (EIS). These results offer a valuable reference for designing high-performance photoanodes on a large scale for photoelectrochemical (PEC) applications.