Dislocation force of scleral flange-fixated intraocular lens haptics

Purpose To measure the dislocation forces in relation to haptic material, flange size and needle used. Setting Hanusch Hospital, Vienna, Austria. Design Laboratory Investigation. Methods, main outcome measures 30 G (gauge) thin wall and 27 G standard needles were used for a 2 mm tangential scleral tunnel in combination with different PVDF (polyvinylidene fluoride) and PMMA (polymethylmethacrylate haptics). Flanges were created by heating 1 mm of the haptic end, non-forceps assisted in PVDF and forceps assisted in PMMA haptics. The dislocation force was measured in non-preserved cadaver sclera using a tensiometer device. Results PVDF flanges achieved were of a mushroom-like shape and PMMA flanges were of a conic shape. For 30 G needle tunnels the dislocation forces for PVDF and PMMA haptic flanges were 1.58 ± 0.68 N ( n = 10) and 0.70 ± 0.14 N ( n = 9) ( p = 0.003) respectively. For 27 G needle tunnels the dislocation forces for PVDF and PMMA haptic flanges were 0.31 ± 0.35 N ( n = 3) and 0.0 N ( n = 4), respectively. The flange size correlated with the occurring dislocation force in experiments with 30 G needle tunnels ( r = 0.92), when flanges were bigger than 384 micrometres. Conclusions The highest dislocation forces were found for PVDF haptic flanges and their characteristic mushroom-like shape for 30 G thin wall needle scleral tunnels. Forceps assisted flange creation in PMMA haptics did not compensate the disadvantage of PMMA haptics with their characteristic conic shape flange.