A contrastive characterization of pure Mg and AZ91D alloy based on the testing of mechanical, corrosion, wear, and erosion properties

Magnesium alloy of grade AZ91D is utilized for a variety of applications in aircraft design and frames, as well as vehicle engine radiators, bumpers, and suspension components to reduce the weight of automobiles. This research compared the mechanical, corrosion, wear, and erosion resistance of pure Mg to that of AZ91 alloy. The corrosion media was NaCl, NaOH, and MgSO4, and the weight loss method was utilised to evaluate corrosion. The pin-on-disc configuration was utilized to assess the dry sliding wear mechanism of the Pure Mg and AZ91D alloy. Pure monolithic Mg and AZ91D magnesium alloy have a low resistance to wear as a result of an increase in contact temperature brought about by a shift of operational conditions. Erosive wear is caused when solid particles in a liquid or air jet strike a surface. Significantly influencing the erosive wear are particle velocity, impact angle, and erodent particle size. In this work, the erosive wear of AZ91D was studied using an Air jet erosion tester. SiO2 was used as the eroding material, and the flow rate of the eroding material and air was 5 gm min-1. The erosive factor experiments are designed using Taguchi orthogonal array (L16). The erosive factor response is erosion rate and primarily regulated by three factors as angle (30 degrees, 45 degrees, 60 degrees, and 90 degrees), time (5 and 10 min) and, contact pressure (1 and 2 bar). The results of the experiments showed that the rate of wear increased with increasing pressure, and that the angle of impact of the jet at 60 degrees caused the most wear of any of the tested angles. Analysis of variance (ANOVA) shows that time is the most important factor in determining erosive rate for AZ91D. SEM is used to investigate the structure and morphology of worn-out materials, and its findings are then confirmed.