Effect of tri-ethylene glycol mono methyl ether and alumina additives on ignition delay in a hydrogen fuelled dual-fuel diesel engine

The diesel engine process including fuel injection, fuel spray, air and fuel mixing, ignition and combustion which influences its performance and emission characteristics. The fuel injection and fuel spray are important process as they are directly related to the quality of fuel which results into fluctuating the ignition and combustion characteristics. Ignition in a diesel engine occurs at the edge of the spray depending on the in-cylinder pressure and temperature. Experiments were conducted on a modified dual-fuel diesel engine (3.5 kW power) with fuel additives, diesel and hydrogen (gaseous fuel) at a stable speed of 1500 rpm. Spray behavior and ignition delay were analyzed to determine the impact of fuel additives in neat diesel combined with hydrogen. Additionally, for dual-fuel Cases, the ignition delay correlations provided for diesel engines have been modified as per the experimental results. The injection velocity was maximized with a 15-25% hydrogen substitution range because the fuel density was reduced to a minimum, but it was decreased with the addition of fuel additives. The SMD for hydrogen with neat diesel and diesel with fuel additives both increased up to 20% hydrogen substitution, whereas for higher hydrogen substitution, the Sauter mean diameter decreased. It was found that the addition of fuel additives in diesel resulted into an increased fuel injection velocity (3.3%) with reduced sauter mean diameter of 3.4% while with the lower substitution of H2 (15%), a maximum increment of 32% in the injection velocity was seen as compared with neat diesel operation. With 15% hydrogen substitution, the change in pressure and density of diesel along with fuel additives accommodated the optimum spray penetration equivalent to neat diesel. In all Cases of hydrogen substitution, the experimental and theoretical values obtained for the chemical ignition delay were found to be consistent with one another except for 35% H2 showing a maximum deviation of 0.2%.