Influence of Different Dielectrics on Process Performance for Electrical Discharge-Assisted Milling of Titanium Alloy

Abstract Electrical discharge-assisted milling (EDAM) is an effective method for machining titanium alloys according to previous research. In this study, the influence of three different dielectrics (kerosene, EDM oil, and deionized water) on the EDAM performance was studied. Experimental studies reveal the influence of different dielectrics by analyzing the discharged signal, surface morphology, and elemental composition of the electrode. The results show that kerosene and EDM oil have a higher discharge frequency than deionized water. After a long discharge time, carbides and debris were generated during the machining process, which affected the micro-hardness and the discharge stability of the machined material. In EDAM, EDM oil can produce the best surface quality, and the surface roughness value was 34.93%, 87.92%, and 121.68% higher than that of kerosene, deionized water, and conventional milling (CM), respectively.