Identification of bedrock depth and blind fault by HVSR analysis along two profiles in Pohang, South Korea considering optimal weather environment and seismometer burial depth

<p>Many deep faults do not reach the earth&#8217;s surface and thus are not recognized. Such faults are rarely mapped by standard surface geological mapping. This seriously hinders seismic risk mitigation efforts. In this study, we applied the horizontal-to-vertical spectral ratio (HVSR) method to identify blind faults invisible at the surface. Despite its simplicity and low-cost implementation, we noticed that HVSR results were unstable using data collected by exposed seismometers or under higher wind speeds. Therefore, three-component seismic sensors for ambient noise observations were buried at different depths to examine the effects of ground coupling, wind speeds, and precipitations. Results from a series of field tests under diverse conditions guided us to establish data selection criteria. The first required condition is that seismic sensors should be buried (>0.3 meters) to secure ground coupling and to avoid any direct exposure to wind or precipitations. The other is that data should be collected at low wind speeds (< 3 m/s). The requirements were applied to ambient noise data along two profiles traversing unnamed and inferred faults in Pohang, Korea. We initially estimated the resonance frequencies for each site, which varied from 0.41 to 2.52 Hz. They were then converted to bedrock depths using an empirical relationship between the resonance frequency and depth to bedrock observed at boreholes in the area. The estimated depths to bedrock along profiles ranged from 8.0 to -472.0 meters. The resulting depth profiles show significant lateral variations in the bedrock depth, including the one near the Gokgang fault at which the thickness to the major impedance contrasts decreased from 196 to 20 meters. Sudden variations were also observed at unexpected locations along the profile. We examined the details, especially for sites of apparent changes in bedrock depth, and compared their characteristics with other geophysical studies, including Vs30, MASW, Bouguer gravity anomaly, and adjacent stations correlation. Their results are all well correlated to each other and indicate rapid changes in bedrock depth. We attribute the rapid changes to vertical displacements by ancient faulting activity.</p>