Numerical simulation and investigation of methane gas distribution and extraction in goaf with U-type ventilation of working face

The accumulated methane in goaf during coal mining may leak into the working face under the airflow influence, which is possibly causing disasters such as methane gas excessive at the working face and seriously threatening the mine safety. This paper first established a three-dimensional numerical model of the mining area under U-shaped ventilation, introducing the gas state equation, continuity equation, momentum equation, porosity evolution equation, and permeability evolution equation to simulate the airflow field and gas concentration field in the mining area under the natural state. The reliability of the numerical simulations is then verified by the measured air volumes at the working face. The areas in the mining area where gas is likely to accumulate are also delineated. Subsequently, the gas concentration field in goaf under the gas extraction state was theoretically simulated for different locations of large-diameter borehole. The maximum gas concentration in goaf and the gas concentration trend in the upper corner were analyzed in detail, and the critical borehole location (17.8 m from the working face) was determined as the optimum location for gas extraction from the upper corner. Finally, a gas extraction test was carried out on-site to evaluate the application effect. The results show that the measured airflow rate has a small error with the simulated results. The gas concentration in the area without gas extraction is high, with the gas concentration in the upper corner being over 1.2%, which is greater than the critical value of 0.5%. The maximum reduction in gas concentration was 43.9%, effectively reducing the gas concentration in the extraction area after employing a large borehole to extract methane gas. The gas concentration in the upper corner and the distance of the borehole from the working face are expressed as a positive exponential function. The field engineering results show that the implementation of the large borehole at a distance of less than 17.8 m from the working face can control the gas in the upper corner to less than 0.5%, effectively reducing the risk of gas in the upper corner. The numerical simulation work in this paper can provide some basic support for the design of an on-site borehole to extract gas from the mining void and reduce the gas hazard in coal mines.