Spatiotemporal Characteristics of the Mud Receiving Area Were Retrieved by InSAR and Interpolation.

The mud receiving area is an important sand storage area for dredging sea sand reclamation and sand-dumping in the waterway. The sediment accumulation area generated in the process of sand dumping and sand storage has an impact on the surrounding transportation facilities and the normal use of the entire sand storage area. From 6 August 2021 to 9 May 2022, The Sentinel-1A 24-view SLC data covering the sludge area were used to monitor the safety around the seawall road by InSAR technology. Synthetic aperture radar differential interferometry (Differential InSAR, D-InSAR) technology can obtain surface micro deformation information through single-time differential interference processing, mainly used for sudden surface deformation. D-InSAR technology detected five accumulation areas with a thickness of more than 10 cm near the seawall road, earth embankment, and cofferdam, and TS-InSAR (Time series InSAR) technology was used to retrieve the deformation of the surrounding road. The road settlement is a slight settlement distributed between +/- 5 mm/a. This paper uses the leveling results combined with variance analysis to verify the fusion of different TS-InSAR methods while considering the area of data loss due to causes such as loss of coherence. This paper also considers the common ground continuity and uses the adjacent interpolation and bilinear interpolation algorithm to improve knowledge of the study area seawall road and the surrounding soil embankment deformation data of the road. Compared with the leveling data, the difference between the missing data and the leveling data after interpolation is stable at about 1-7 mm, which increases the risk level of part of the road which needs to be maintained. It provides a reference method to make up for the missing data caused by ground incoherence.