High-accuracy calibration method for an underwater one-mirror galvanometric laser scanner.

Three-dimensional (3D) perception of deep-sea targets is the key to autonomous operation of underwater equipment (e.g., underwater robots). Underwater one-mirror galvanometric line-laser scanner has advantages for short-range measurement, but it is difficult to achieve high calibration accuracy due to installation errors and refraction effects. For this reason, in this paper, a high-accuracy refraction-considered and installation-error-independent calibration method is proposed for the vision system. Firstly, to address the difficulty of aligning the incident light plane with the galvanometer shaft, a high-accuracy land-based installation-error-independent model is proposed, which avoids the influence of the installation errors and allows the real shaft axis and the light-plane cluster poses to be calculated using only three light planes. Subsequently, considering the underwater refraction, a 3D model is established for simulating refractive behaviors of the light-plane cluster, and then a partition-based method is proposed for calibrating the underwater light-plane cluster, which further improves the calibration accuracy of the scanner in underwater measurement scenarios. Finally, a one-mirror galvanometric laser scanner is developed in the laboratory to verify the calibration accuracy and to perform the 3D measurement experiments of underwater targets. The results show that the calibration accuracy of the proposed land-based installation-error-independent model is improved 2 times more compared with the traditional installation-error-dependent model. Additionally, the measurement accuracy of the scanner for the standard sphere is 11.98 µm and 12.75 µm in the air and underwater measurement scenarios, and the two measurements are in good agreement. The above results comprehensively verify the high accuracy of the calibration method proposed in this paper.