Cyclic Deformation Mechanism and Fracture Behaviour of 316l Stainless Steel Under Thermomechanical Fatigue Loading

Thermomechanical fatigue (TMF) behaviour of 316L is investigated based on the internal stress and microstructural characterization at various cyclic stages. Results reveal that the cyclic stress response shows initial hardening followed by cyclic softening at a high strain amplitude, while presenting continuous cyclic hardening as the strain amplitude decreases. Among these, Out-of-phase TMF always shows cyclic softening irrespective of strain amplitude. It is important to note that the hardening of back stress and friction stress contribute to the initial and subsequent cyclic hardening. In contrast, the subsequent cyclic softening is mainly dominated by the reduced friction stress. It is observed that the proliferation of dislocations at grain boundaries and the enhanced dislocation interactions within the grains are primarily responsible for the hardening of back stress and friction stress, respectively. Specifically, the cyclic softening of friction stress is attributed to the annihilated dislocations as a result of cross-slip. It is also found from the hysteresis curves that the intensity of dynamic strain ageing is related to strain amplitude, loading history and phase angle, which correlates to the occurrence of cross-slip, the diffusion rate of the solute atom, the density of point defect and the mobility of vacancies. Finally, the effect of loading conditions on fracture behaviour is demonstrated from the point view of crack sources, secondary cracks, creep cavities and oxidation damage.