Submicron Ti(C,N)-based cermets with improved microstructure using high-energy milled and subsequent heat-treated ultrafine Ti(C,N) powders

Ti(C,N)-based cermets with ultrafine or submicron black core-rim grains are attracting candidates for high-quality tools and dies, due to their high hardness and strength. However, high chemical activity of ultrafine Ti(C,N) powders lead to the increased instability and difficulty to control the sintering process, since the denitrification and interface diffusion are accelerated during the solid-state reaction. Based on this, owing to the unrealized commercial ultrafine-grade powders, ultrafine Ti(C,N) powders with an average grain size around 150 nm, low oxygen content and few dislocations are fabricated via the high-energy ball milling and subsequent heat treatment of commercial micron Ti(C,N) powders. Related morphology evolution, microstructure and composition of the ultrafine Ti(C,N) powders are investigated. Dense submicron Ti(C,N)-based cermets with grain size of 0.62 μm and uniform core-rim phases are successfully prepared by using the as-fabricated ultrafine Ti(C,N) powders. Compared to cermets via the conventional high-energy milling route, submicron Ti(C,N)-based cermets exhibit higher hardness of 1750 ± 40 N/mm2, bending strength of 1960 ± 135 MPa, and satisfactory fracture toughness of 9.2 MPa m1/2, owing to smaller grain size, uniform microstructure and partial black core-rim grains.