3D Printing-Assisted Supramalleolar Osteotomy for Ankle Osteoarthritis

Ankle osteoarthritis (OA) is an important factor that causes pain and dysfunction after ankle joint movement. In early and mid-term ankle OA, supramalleolar osteotomy can delay the progression of disease and maximize the preservation of ankle joint function. Three-dimensional printing (3DP) technology has brought us new hope, which can improve the accuracy of osteotomy, reduce the number of fluoroscopy, reduce the amount of blood loss, and achieve personalized and accurate treatment. The data of 16 patients with ankle OA in our center from January 2003 to July 2020 were retrospectively analyzed and divided into the 3DP group and the traditional group according to different treatment methods. Seven patients in the 3DP group used the 3DP personalized osteotomy guide; nine patients were treated by traditional osteotomy. All patients were followed up for 13.9 +/- 3.1 months after the operation. The operation time in the 3DP group was 126.4 +/- 11.1 min, its intraoperative blood loss was 85.7 +/- 24.1 mL, and its intraoperative fluoroscopy time was 2.4 +/- 0.2, which were all significantly less than 167.3 +/- 12.2 min, 158.3 +/- 22.8 mL, and 5.8 +/- 0.2 times in the traditional group (P < 0.05), respectively. In the 3DP group, its postoperative tibial anterior surface (TAS) angle was 90.6 +/- 0.3 degrees and the talar tilt (TT) angle was 2.2 +/- 0.6 degrees, which were all significantly different compared with its preoperative data of 83.4 +/- 1.7 and 8.0 +/- 1.5 degrees, respectively (P < 0.05). Compared with traditional osteotomy, 3DP-assisted supramalleolar osteotomy for varus and valgus ankle OA can significantly shorten the operation time and reduce intraoperative bleeding and the frequency of intraoperative fluoroscopy; personalized 3DP osteotomy guides and models can assist in the accurate correction of varus deformity during operation, restore the lower limb alignment, and improve the biomechanical status of the lower limbs. In addition, the 3DP of porous tantalum has good histocompatibility, and its interface structure and porosity are more conducive to bone ingrowth. For complex bone defects and revision prostheses, matching implants can be printed individually, which could realize the personalized precise treatment.