Mechanical Properties of Polyvinyl Alcohol Fiber-Reinforced Cementitious Composites after High-Temperature Exposure

The mechanical properties of cementitious composites before and after exposure to high temperature are affected by calcium-silicate-hydrate (C-S-H) gels. To evaluate the effects of high temperature, plyvinyl alcohol (PVA) fiber content, and the cooling method on properties of cementitious composites, physical, mechanical, and microscopic tests were performed in this study. The target temperatures were 25, 100, 200, 300, 400, 600, and 800 degrees C. The PVA fiber contents were 0.0, 0.3, 0.6, 0.9, 1.2, and 1.5 vol%. The high-temperature resistance of PVA fiber-reinforced cementitious composite (PVA-FRCC) specimens was investigated through changes in their appearance, mass loss, compressive strength, splitting tensile strength, flexural strength, and microstructure. The results showed that PVA fibers reduced the probability of explosion spalling in the PVA-FRCC specimens exposed to high temperatures. The mass loss rate of samples exposed to temperatures below 200 degrees C was small and lower than 5%, whereas a significant mass loss was observed at 200 degrees C to 800 degrees C. A small rise in the cubic compressive and splitting tensile strengths of samples was found at 400 degrees C and 300 degrees C, respectively. Below 400 degrees C, the fibers were beneficial to the mechanical strength of the PVA-FRCC specimens. Nevertheless, when the temperature was heated above 400 degrees C, melted fibers created many pores and channels, which caused a decrease in the strength of the specimens. The method of cooling with water could aggravate the damage to the cementitious composites exposed to temperatures above 200 degrees C. High temperature could lead to the decomposition of the C-S-H gels of the PVA-FRCC samples, which makes C-S-H gels lose their bonding ability. From the perspective of the microstructure, the structure of PVA-FRCC samples exposed to 600 degrees C and 800 degrees C became loose and the number of microcracks increased, which confirmed the reduction in macro-mechanical properties.