Sequential digital occlusal analysis in patients with skeletal Class III malocclusion with orthognathic surgery: Surgery-first vs orthodontic-first approach.

INTRODUCTION:This study compared changes in occlusal characteristics in patients with skeletal Class III malocclusion with surgery-first approach (SFA) and those with orthodontic-first approach (OFA) through digital occlusal analysis. METHODS:In this prospective study, 90 consecutive subjects were divided into control, OFA, and SFA groups (30 per group). Force discrepancy, occlusal time, tooth contact, center of force, and force-time graph pattern were calculated for all samples using the T-Scan III system. Between-group differences were analyzed using a 1-way analysis of variance and generalized estimating equations. These parameters were calculated at the following time points: preoperatively, 1-month postoperatively (T1), 4-months postoperatively, and 1-year postoperatively (T3). RESULTS:No significant differences were observed in the parameters between the experimental groups. The force discrepancy of the OFA and SFA groups decreased, approaching the value of controls at T3. The occlusal time significantly increased at T1 and progressively decreased at T3. The initial contact and maximum force were most frequently observed on molars, and its maximum force significantly decreased by 5.72% and 7.40% in the OFA and SFA groups at T3, respectively. The number of tooth contact was significantly reduced at T1 and gradually increased at T3. Moreover, after surgery, the force-time graph pattern was normalized, and the center of force tended to be more centric; however, the most frequent trajectory revealed premature contact during closing. CONCLUSIONS:No significant difference was found in all parameters between the OFA and SFA groups. Occlusion deteriorated at 1 month postoperatively but gradually improved at 1 year postoperatively, approaching the controls.