3D Flame surface density measurements via orthogonal cross-planar mie scattering in a low-turbulence bunsen flame

Quasi-instantaneous Mie scattering measurements were conducted to determine the flame surface location using two orthogonal planes to obtain the 3D orientation and measurement of 3D flame surface density (FSD) on a stabilised piloted Bunsen burner with turbulence levels of 1 to 2.5 times the laminar flame speed. A double-pulsed 527 nm high-frequency laser (part of a high-frequency particle image velocimetry dual-head setup) was split into two separated laser beams through a polarizer to generate laser sheets at 3 kHz on a vertical plane and a horizontal plane. The vertical plane across the centerline of the Bunsen-stabilized flame was kept constant, whilst the height of the horizontal plane was adjusted from the base of the flame for different heights. The flame edge was defined as the location where droplet tracers disappear, and calculated based on the local change in the number density of the flame edge. Projections of the flame normal vector onto two measurement planes were used to calculate directing angles on each plane, and the 3D FSD was estimated based on the measured angles at the intersecting lines of two planes. A comparison of the 2D to 3D FSD magnitudes was made, for cases with and without mean angle corrections. The results show that the 2D FSD approximations are lower than the 3D measurements by a factor of 20–30% if uncorrected, and up to 28% after corrections.