Rhodotron and Rotating Target: A Solution Towards Micro-Spot for High Energy and High Dose Rate Bremsstrahlung Sources

High energy over MeV bremsstrahlung sources that employ normal conducting radio frequency linear accelerators have expanding applications in industrial computerized tomography (CT) for non-destructive inspection and evaluation. The X-ray spot size that mainly affects the imaging quality is yet limited by the electron beam width in the high resolution CT systems. In a short exposure time, high beam power is required to generate sufficient photons to improve the signal to noise ratio of imaging. However, with similar to kW level of average beam power these linear accelerators usually have a beam spot size over 1 mm since the temperature rising due to the beam energy deposition in the target should be far below its melting point. We propose a concept of using a Rhodotmn-based accelerator to provide high power electron beams in a long duration pulse and a rotating target to mitigate the overheating issue, such that the gap between micro-spot and high dose rate can be bridged in the high energy bremsstrahlung sources. This article presents an in-depth simulation work to discuss and evaluate this scheme of X-ray source. The simulations of beam dynamics in the accelerator and bremsstrahlung process in the target predict the generated X-rays with a spot size as small as 68 mu m at full-width half-maximum and a dose rate as high as 4700 cGy/min from a 9 MeV electron beam interacting with a 1 mm thickness tantalum target. Further thermal analysis in the rotating target indicates a significant improvement of beam power handling in comparison with the conventional stationary one.