Effect of Al Layer Thickness on the Bonding and Mechanical Behavior of a Mg-(Al-)Ti Laminated Sheet Prepared by Hot-Rolling after Differential Preheating Treatment

Mg-(Al-)Ti laminated sheets with large bonding interfaces were prepared by a differential temperature hot-rolling process, in which the preheating treatment of Ti was 25-100 degrees C higher than that of Mg. The rolled sheets contained different Al layer thicknesses (<= 0.05 mm), and the thickness of the diffused region at the interface of 3-7 mu m was formed by rolling at 175 degrees C. The interfaces were the solid-solution regions of Mg(Al) and Ti(Al), and no intermetallic compounds were generated during both the rolling process and annealing treatment. The hardness of the interfaces was 16-30% greater than that of the Mg matrix and Ti matrix. The results of mechanical tests displayed that the Mg-(Al-)Ti sheets exhibited higher strength and elastic modulus compared to those of the rolled AZ31B sheet. Their UTS and YTS were about 223-460 MPa and 303-442 MPa, respectively, with an elongation of 0.04-0.17 and high elastic modulus of 52-68 GPa. The Mg-Ti (containing about 62 at.% Mg) rolled sheet exhibited the most excellent strength. The UTS and YTS were about 460 MPa and 442 MPa, with an elongation of 0.04 and elastic modulus of 61.5 GPa. Additionally, Mg-Ti sheets with thin Ti thickness possessed a higher work-hardening rate (n), as well as hardening rate, than the rolled Mg-Al-Ti sheets. This is because fractured Ti pieces around the interfaces have a significant strengthening effect. This study provides a simple method for fabricating Mg-(Al-)Ti sheets with high elastic modulus.