Effect of grain boundary state and grain size on the microstructure and mechanical properties of alumina obtained by SPS: A case of the amorphous layer on particle surface

The work was aimed at the investigation of kinetics of Spark Plasma Sintering (SPS) of the α-Al2O3 particles with amorphous surface layers and investigation of the effect of the amorphous layers on the grain growth and on the mechanical properties of alumina. The objects of investigations comprised:(i) submicron α-Al2O3 powder, (ii) submicron α-Al2O3 powder with the amorphous layers on the particles' surfaces, and (iii) the fine-grained α-Al2O3 powder. The submicron powders (i) and (ii) were used to analyze the effect of the amorphous layers on the sintering kinetics. Powders (i) and (iii) were used to analyze the effect of the initial particle sizes on the shrinkage kinetics. The effect of the temperature regime and of the rate (Vh) on the shrinkage kinetics of the submicron and fine alumina powders has been studied. The shrinkage curves were analyzed using the Young–Cutler and Coble models. The sintering kinetics was shown to be determined by the intensity of grain boundary diffusion for the submicron powders and by simultaneous lattice diffusion and grain boundary one for the fine powders. The amorphous layers on the surfaces of the submicron α-Al2O3 particles were found to affect the grain boundary migration rate and the Coble equation parameters at the final stages of SPS. The abnormal characteristics of the alumina ceramics sintered from the submicron powder with the amorphous layers on the particles’ surfaces were suggested to originate from the increased concentration of the defects and of the excess free volume at the grain boundaries formed during crystallization of the amorphous layers.