Modelling the thermal inactivation of spores from different phylogenetic groups of Bacillus cereus

The objective of this work is to match available phylogenetic information for Bacillus cereus strains with published thermal resistance parameters (D90°C, z) and to use this information to develop refined inactivation models for B. cereus sensu lato. To do so, the thermal resistance parameters were retrieved for 57 strains of B. cereus that could be assigned to a phylogenetic group. This information was used to build specific distributions for D90°C and z for the different phylogenetic groups of B. cereus to build refined thermal inactivation models for B. cereus. For validation purposes, thermal parameters were also retrieved for additional strains of unknown groups, but which had been classified as psychrotrophic or mesophilic. Monte Carlo simulations were first performed assuming that the model parameters D90°C and z are independent. However, based on the observation that combinations of very high D90°C and high z-values were not reported, an alternative Monte Carlo simulation set was explored for the phylogenetic Groups with very high z-values (i.e.i.e. Groups IV and VI). With both simulation sets, the predicted lower and upper limits of the D-values are close to the lowest and highest D-values reported in two previous meta-analysis studies. However, a better correspondence between the predicted and observed limits is obtained when using the alternative simulation set.