Influence Of Hydrogen Saturation On The Structure And Mechanical Properties Of Fe-17cr-13ni-3mo-0.01c Austenitic Steel During Rolling At Different Temperatures

Introduction. The development of hydrogen energy implies a decrease in the dependence of various human activities on fossil energy sources and a significant reduction in carbon dioxide emission into the atmosphere. Therefore, the requirements for the quality of structural materials. which have the prospect of being used for storage and transportation of hydrogen, as well as for the creation of infrastructure facilities for hydrogen energy, are increasing. Therefore, the scientific researches on the hydrogen-assisted microstructure and mechanical behavior of structural materials in various loading schemes are of great importance. The aim of this work is to establish the effect of chemical-deformation treatment, including rolling combined with hydrogen saturation, on the microstructure, phase composition. and mechanical properties of 316L-type austenitic stainless steel. Methods. Transmission electron microscopy and hackscattered electron diffraction, X-ray diffraction, X-ray phase and magnetic phase analysis, microindentation and uniaxial static tension are utilized. Results and Discussion. It is shown experimentally that Mier rolling with 25 and 50 % upset, the morphology of the defect structure and the phase composition of 316L steel substantially depends on the deformation temperature (at room temperature or with the cooling of the samples in the liquid nitrogen) and on hydrogen saturation rate (for 5 hours at a current density of 200 mA/cm2). The main deformation mechanisms of the steel in rolling are slip, twinning, and microlocalizat ion of plastic flow, which all provide the formation or ultrafine grain-subgrain structure in the samples. In addition, deformation-induced epsilon and alpha' martensitic phases are formed in the structure of the rolled samples. Regardless of the regime of chemical-deformation processing, grain-suhgrain structures with a high density of deformation defects are formed in steel, but its morphologies are dependent on the processing regime. The experimental data indicate that both preliminary hydrogen saturation and a decrease in the deformation temperature contribute to the more active development of mechanical twinning and deformation-induced phase transformations during rolling. Despite the discovered effects on the influence of hydrogen saturation on the deformation mechanisms and the morphology of a defective microstructure formed during rolling, preliminary hydrogenation has little effect on the mechanical properties of steel at a fixed degree and temperature of deformation.These data indicate that irrespective of the morphology of the defective grain-subgrain structure, grain refinement, accumulation of deformation defects and an increase in internal stresses lead to an increase in the strength characteristics of the steel.