Design And Control Of An Ultrasonic Surface Haptic Device For Longitudinal And Transverse Mode Comparison

The design and closed loop control of a device able to produce both longitudinal mode and transverse mode vibration, at about the same resonance frequency (60 kHz) are presented in this article. The structure uses an array of piezo-ceramics. A dynamic analysis is performed on the obtained modes, and their dynamic lumped parameters are identified. A closed loop control is performed to maintain the desired vibration amplitude in the presence of a finger. Longitudinal and transverse motion cartographies show that the objective of achieving and controlling pure modes independently has been achieved. Using this device, tribological, psychophysical and energetic analyses are carried out. The analyses show that in terms of friction measurements and perception, both modes produce equivalent results. In terms of active power losses, an advantage of the longitudinal mode over the transverse mode is observed due to the interaction with the finger. (c) 2021 Elsevier B.V. All rights reserved.