Direct microscopic monitoring of initial and dynamic clot lysis using plasmin or rt-PA in an in vitro flow system.

INTRODUCTION:Plasmin is a direct-acting thrombolytic agent with a favorable safety profile upon intra-arterial delivery in pre-clinical and phase I studies. However, the thrombolytic efficacy of plasmin, relative to that of rt-PA, remains to be established. We have compared the dynamics of clot lysis with plasmin or rt-PA in an in vitro perfusion system, in which thrombolytic agent is administered locally, allowed to induce lysis for short intervals, then washed with plasma in a re-circulation circuit. MATERIALS AND METHODS:Whole blood human clots were prepared in observation chambers, exposed to plasmin or rt-PA at equimolar concentrations (1.2/1.0, 1.8/1.5 and 2.4/2.0 mg/ml) for measured intervals of time, followed by perfusion with human plasma. Clot size was monitored by digital analysis of sequential photographs obtained through an optical microscope. RESULTS:Plasma perfusion after incubation with thrombolytic agent rapidly removed superficial clot fragments. This initial decrease in clot size was greater with plasmin than with rt-PA when tested at the highest concentrations of agent (0.63 ± 0.11 vs. 0.30 ± 0.11, p=0.001 for clots with non-cross-linked fibrin and 0.53 ± 0.15 vs. 0.14 ± 0.15, p=0.02, for clots with cross-linked-fibrin). Subsequent clot lysis during plasma flow was greater after prior incubation with rt-PA. Longer incubation times of plasmin resulted in larger portions of the clot being washed free. Repeated plasmin incubations and plasma perfusions of a clot successfully induced stepwise reductions in clot size. CONCLUSIONS:Initial clot lysis is greater with direct exposure using plasmin than rt-PA. During washout and circulation with plasma, rt-PA induced continued clot lysis, while plasmin lysis was curtailed, presumably because of plasmin inhibition.