Tribological Investigation of Ceramic Incorporated Novel Compositionally Graded Multilayer Tungsten Alloys

In this study, novel compositionally graded tungsten alloys incorporating ceramics were prepared using mechanical alloying and pressure-assisted vacuum hot press (VHP) sintering. Three distinct tungsten compositions (W1, W2, and W3) were developed with varying alloying elements and reinforcements, were stacked layer-wise, and then sintered using VHP. Scanning electron microscopy (SEM) and X-ray diffraction (XRD) techniques were employed to analyze the morphology and microstructural features of synthesized alloys. The effect of alloying elements and reinforcements on mechanical properties and wear behavior was examined. The results showed improvement in mechanical characteristics and enhanced wear resistance of the compositionally graded tungsten alloys. The hardness was increased due to the formation of carbide phases during milling and sintering. The W1 side exhibited a hardness of 8.4 GPa, while the W3 side reached a hardness of 13.3 GPa. Additionally, the wear behavior of both sides (W1 and W3) was also investigated under different applied loads. At a load of 10 N, the W1 surface exhibited a minimum specific wear rate of 3 x10-6 mm3/Nm, attributed to the presence of MWCNTs and WC phase. However, the W3 surface reinforced with TiC and cBN showed a minimum specific wear rate of 9 x10-7 mm3/Nm at a higher load of 20 N. This indicates that the W3 side possessed superior hardness and wear resistance ability as compared to the W1 side of compositionally graded tungsten alloys. The novel compositionally graded approach is useful for developing tungsten alloys with tailored mechanical properties for wear resistance applications.