Tailoring Microstructure and Mechanical Properties of Additively Manufactured Inconel 625 by Remelting Strategy in Laser Powder Bed Fusion

This study investigates the effect of laser power applied for a remelting scan in the laser powder bed fusion process on the formation of a bimodal microstructure and its impact on the mechanical properties of Ni-based Inconel 625 superalloy. Comparison of primary and remelting scans at similar surface energy densities revealed that the melt pools obtained in the remelting scan are smaller than in the primary scan. To achieve comparable remelted melt pool sizes, the 25 pct increase in energy is required. The shape and size of the remelted melt pools significantly affect the microstructure and material texture. The lower surface energy density in laser powder bed fusion favors the formation of a bimodal microstructure with large columnar grains and fine grain bands. Application of higher energy results in the formation of large columnar grains with Goss texture along build direction and separated by a large amount of low angle grain boundaries. Remelting scan also affects reduction of porosity and increasing of the area fraction of nanometric oxide inclusions. The study revealed that the samples subjected to a remelting laser scan and tensile tested along the direction of columnar grains exhibited higher ductility, which was associated with a slight decrease in the ultimate tensile strength compared to the samples that were not remelted. It was demonstrated that the remelting scan in the laser powder bed fusion process offers the possibility of improving the reliability of additively manufactured Inconel 625 superalloy by reducing porosity and tailoring its microstructure towards single-crystal-like, and thus improving the mechanical properties.