Member Capacity of Cold-rolled Aluminium Alloy Channel Columns - Part I: Experimental Investigation

Cold-rolled aluminium alloy sections have been recently introduced in Australia as newly developed thin-walled products. To fabricate these sections, the roll-forming process used in cold-formed steel production has been employed, which has proven to be more cost-effective than the conventional extrusion process. This paper describes a series of compression tests to investigate member buckling behaviour and ultimate strengths of cold-rolled aluminium alloy 5052-36 channel columns. Twenty-eight specimens of three commercially available sections (C10030, C25025 and C40030) were tested at the University of Sydney. Two configurations of end boundary conditions were specially designed to capture flexural, flexural-torsional and local-global interaction buckling failure modes. Prior to testing, initial geometric imperfections were measured using a laser scanning method, and flat/corner coupons were tested to determine compressive and tensile strengths of the aluminium alloy material. The experimental results are compared with ultimate column strength predictions by current Australian/New Zealand, North American and European design specifications for aluminium structures. Additionally, the test results provide data for calibration of finite element models of cold-rolled aluminium structural members for use in parametric and similar studies. A companion paper describes such parametric study and the derivation of new design guidelines for member buckling of cold-rolled aluminium channel columns based on the numerical parametric data and the experimental data presented herein.