3D-Printed Fluorescent Hydrogel Consisting of Conjugated Polymer and Biomacromolecule for Fast and Sensitive Detection of Cr(VI) in Vegetables.

Portable fluorescent film sensors offer a solution to the contamination issue in homogeneous sensor detection systems. However, their special structure leads to low sensitivity and a long response time, resulting in a significant scientific challenge limiting their development and application. In this work, we propose a dual design strategy to prepare highly sensitive film sensors for rapidly detecting Cr2O72-. Specifically, P(Fmoc-Osu)-SA hydrogel films were developed by integrating the biological macromolecule sodium alginate (SA) with the conjugated polymer poly(N-(9-Fluorenylmethoxycarbonyloxy)succinimide) (P(Fmoc-Osu)), using both mold and inkjet 3D printing methods. The "molecular wire effect" of the sensing unit P(Fmoc-Osu) and the water channel within the film substrate are responsible for the improved sensitivity and the reduced response time of this thin film sensor. P(Fmoc-Osu)-SA hydrogel films prepared by these two methods can rapidly detect Cr2O72- with limits of detection of 1.18 and 0.078 nM, respectively. Considering that 3D-printed hydrogel films can be tailored to different shapes according to detection needs, the P(Fmoc-Osu)-SA hydrogel films produced from this method were effectively applied in vegetable samples. This study provides an innovative and effective strategy for the development of biocompatible hydrogel sensors that offer the potential for determining trace amounts of Cr2O72- in agriculture.