The improvement of electrochemical performance by mixing InF3 in Li5.3PS4.3Cl1.7 solid electrolyte

All-solid-state batteries (ASSBs) employing solid electrolytes (SE) are currently gaining attention as next-generation energy storage devices. Solid electrolytes exhibit higher energy densities and operation across a wide temperature range than liquid electrolytes. The solid electrolyte acts as a separator, providing higher mechanical strength than polymer separators. This helps prevent cell deterioration and short circuit issues caused by lithium dendrite growth during charge – discharge cycles. Consequently, lithium metal, previously challenging to apply in conventional lithium-ion batteries, can be utilized as an anode electrode material. Sulfide-based solid electrolytes offer advantageous mechanical properties and high ionic conductivity. However, their narrow chemical/electrochemical stability window poses challenges. During the charging-discharging process of a battery with a lithium metal anode, a reduction decomposition reaction of the solid electrolyte occurs. On the other hand, Lithium Fluoride (LiF) exhibits low electronic conductivity due to a wide band gap but has a broad electrochemical stability window. In this study, we prepared a mixture of Li5.3PS4.3Cl1.7 with InF3 to generate an artificial solid electrolyte interphase (SEI) containing LiF. We confirmed the structural properties using powder X-ray diffraction (XRD). The XRD pattern showed the maintenance of the argyrodite structure, with only an increase in the peak intensity corresponding to InF3. The optimized solid electrolyte-based ASSB demonstrated a higher initial discharge capacity of 172.8mAh/g, a coulombic efficiency of 78.54%, and a capacity retention rate of 93.6%, outperforming ASSBs based on the bare solid electrolyte (Li5.3PS4.3Cl1.7).