Wet and dry etching of ultrawide bandgap LiGa₅O₈ and LiGaO₂

Crystalline thin films of LiGa5O8 have recently been realized through epitaxial growth via mist-chemical vapor deposition. The single crystal, spinel cubic LiGa5O8 films show promising fundamental material properties and, therefore, make LiGa5O8 a potential enabling material for power electronics. In this work, chemical resistance and etch susceptibility were investigated for the first time on crystalline LiGa5O8 thin films with various wet chemistries. It was found that LiGa5O8 is very chemically resistive to acid solutions, with no apparent etching effects observed when placed in concentrated acid solutions of HCl, H2SO4, HF, or H3PO4 at room temperature. In contrast, orthorhombic (010) LiGaO2 shows effective etching in HCl solutions at varying dilution concentrations, with etch rates measured between 8.6 [1000:1 (DI water: HCl concentration)] and 6092 nm/min (37 wt. % HCl). The inductively coupled plasma reactive ion etching (ICP-RIE) of LiGa5O8 using BCl3/Ar and CF4/Ar/O-2 gas chemistries was investigated. The etching rate and surface morphology of etched surfaces were examined as a function of RIE and ICP power. Using a CF4/Ar/O-2 gas chemistry with an RIE power of 75 W and an ICP power of 300 W resulted in smooth etched planar surfaces while maintaining an etch rate of similar to 24.6 nm/min. Similar dry etching studies were performed for LiGaO2. It was found that the BCl3/Ar gas chemistry was better suited for LiGaO2 etching, with similar surface morphology quality being obtained after etching as prior etching when a RIE power of 15 W and an ICP power of 400 W is utilized.