An investigation on metallurgical features and joint characteristics of ultrasonic spot welded Al-Ni sheets

Several potential benefits in joining thin, dissimilar and highly conductive metals in a solid-state environment make ultrasonic welding (USW) a popular method for building Li-ion battery packs. The USW method is highly complex and relies on multiple factors. In this study, aluminum (AA1100) and nickel (UNS N02200) dissimilar sheets were ultrasonically welded using various process parameters. Plastic deformation, microstructural development, and the corresponding mechanical characteristics of the joints were evaluated qualitatively and quantitatively. The joint strength and critical intensity factor values seemed to rise until the welding duration of 0.3 s, following which there was a subsequent drop in their values. Based on the mechanical analysis, it is observed that the optimal condition records an amplitude of 68 mu m, a weld time of 0.3 s, and a clamping pressure of 0.24 MPa. It showed that the joint performance was significantly impacted by the plastic deformation and microstructural changes at the weld region. On the Al side, substantial plastic deformation was observed, and it was primarily attributed to the sonotrode knurls' penetration. The Al sheet's thickness was reduced by more than 40%. The microhardness readings at the welding region experienced diminution due to the acoustic softening effect. The cross-section and fracture surfaces of the Al/Ni weld exhibited several distinct microstructural characteristics, such as atomic diffusion, crimped interface, dimple pattern, and swirl pattern flow. Additionally, the diffusion zone is also investigated using X-ray diffraction analysis. These observations offer valuable insights for enhancing weld quality and controlling the overall welding process.