Femoral interference screw divergence as a result of anteromedial portal insertion and outside-in FlipCutter femoral tunnel drilling: A cadaveric study

Aims and objectives To investigate whether interference screw fixation through an anteromedial portal into an outside-in drilled femoral tunnel via a flip cutter results in acceptable hardware position. Materials & methods 10 cadaveric knees underwent ACL-reconstruction with patellar BTB autograft. Femoral tunnel drilling was performed utilizing an outside-in flip cutter drill and interference screws for femoral fixation. Lateral and anterior-posterior (AP) fluoroscopic images were taken to measure screw divergence within the femoral tunnel. The means of AP and lateral divergence angles were compared using two-tailed t-tests. Results Using the flip cutter, the AP and lateral divergence angles were 7.3° ± 4.5° and 9.3° ± 9.3°, respectively, while the total divergence angles were 16.6° ± 11.8°. Divergence angles using a cannulated reamer were found to be 14.4° ± 2.5° and 6.8° ± 2.8° for AP and lateral, respectively and 21.1° ± 5.2° for the total divergence. The AP divergence angles using the flip cutter were significantly less than those reported using a cannulated reamer (p = 0.001). Conclusions The flip cutter method resulted in significantly reduced divergence angle between the screw and graft when compared to previous cadaveric studies in the coronal plane. There was no significant difference in divergence angle in the sagittal plane. Both methods appear to result in divergence angles below the threshold which would be considered to significantly decrease pull-out strength. Large standard deviations also reflect limited sample size but may also suggest more variability in divergence when compared to historical control set. This study clearly establishes the outside-in technique using a retrograde reamer as a viable independent femoral drilling solution for ACL reconstruction when using a BTB autograft with a femoral interference screw.