First clinical experience following the consensus guide for calibrating a proton stopping power ratio curve in a new proton centre

Background and Purpose This work introduces the first assessment of CT calibration following the ESTRO’s consensus guidelines and validating the HLUT through the irradiation of biological material. Methods Two electron density phantoms were scanned with two CT scanners using two CT scan energies. The stopping power ratio (SPR) and mass density (MD) HLUTs for different CT scan energies were derived using Schneider’s and ESTRO’s methods. The comparison metric in this work is based on the Water-Equivalent Thickness (WET) difference between the treatment planning system and biological irradiation measurement. The SPR HLUTs were compared between the two calibration methods. To assess the accuracy of using MD HLUT for dose calculation in the treatment planning system, MD vs SPR HLUT was compared. Lastly, the feasibility of using a single SPR HLUT to replace two different energy CT scans was explored. Results The results show a WET difference of less than 3.5% except for the result in the Bone region between Schneider’s and ESTRO’s methods. Comparing MD and SPR HLUT, the results from MD HLUT show less than a 3.5% difference except for the Bone region. However, the SPR HLUT shows a lower mean absolute percentage difference as compared to MD HLUT between the measured and calculated WET difference. Lastly, it is possible to use a single SPR HLUT for two different CT scan energies since both WET differences are within 3.5%. Conclusion This is the first report on calibrating an HLUT following the ESTRO’s guidelines. While our result shows incremental improvement in range uncertainty using the ESTRO’s guideline, the prescriptional approach of the guideline does promote harmonization of CT calibration protocols between different centres.