Operational Monitoring of Thermal Dynamics in Deep Geothermal Production and Injection Wells with Fiber Optics from the Surface to the Reservoir

In order to gain insights into the hydraulic and thermal long-term behavior of deep geothermal boreholes during operation, a fiber-optic monitoring (FOM) system was implemented at the Stadtwerke Munich's (SWM) geothermal plant 'Schäftlarnstrasse' in the national project Geothermal-Alliance Bavaria (GAB). The permanently installed fiber optic cables enable continuous measuring of the temperature in boreholes with high spatial and temporal resolution via Distributed Temperature Sensing (DTS) and of acoustics/vibration via Distributed Acoustic Sensing (DAS). In 2019, one production and one injection well were equipped with FOM in different setups and have been collecting data since then. In the injector, the cable was cemented behind the anchor pipe in the upper section of the borehole, whereas the producer was equipped with a fiber-optic cable until the total depth of the reservoir. Additionally, a fiber-optic gauge provides pressure and temperature at the top of the reservoir in this well. Among other things, precise inflow profiling in the reservoir section of the producer could be carried out using the temperature data, which helps deepen the understanding of the hydraulic behavior of the reservoir. Changes over time in the temperature of the produced thermal water can be traced back to changes in the hydraulically active zones or inflow temperatures in the reservoir. Other factors that influence the wellhead temperature, such as borehole heat losses to the surrounding rock, can be quantified using the DTS data. At the beginning of 2024, a third fiber-optic cable will be installed in an injection well at the Schäftlarnstrasse geothermal site. A similar setup as in the production well will allow for continuous measuring in the entire borehole until total depth (TD) and pressure and temperature from p/T gauges at the top of the reservoir and at TD. Therefore, both production and injection conditions in the reservoir and wellbore will be continuously monitored at all depths using DTS and DAS for the first time. We present the first interpretations of the data collected from the newly installed FOM in the injection well as well as insights into the long-term monitoring of the hydraulic and thermal dynamics in the production well to underline the importance of permanent downhole monitoring to ensure efficient and sustainable use of the geothermal reservoir.