Design of an Internet of Things (IoT)-Based Photosynthetically Active Radiation (PAR) Monitoring System

Photosynthetically Active Radiation (PAR) is an important parameter in the plant photosynthesis process, which can relate to plant growth, crop water use, and leaf gas exchange. Previously, many researchers utilized commercially available sensors to monitor PAR. The high cost of the commercially available PAR sensors has limited researchers, agricultural professionals, and farmers to use and expand PAR monitoring in agricultural lands. Thus, this paper focuses on designing an affordable Internet of Things (IoT)-based PAR sensor monitoring system including 3D-printed enclosures (waterproof) for the sensors, performance evaluation of multiple light sensors, solar powering configuration, cloud setup, and cost analysis. Three sensors, including VTB8440BH photodiode, SI 1145, and LI-190R sensors, were evaluated. The 3D-printed waterproof enclosures were designed for the photodiode and SI 1145. Particle Boron was used for recording and sending the sensor data to the IoT webserver. Both the photodiode and SI 1145 were compared to LI-190R, which is the industry standard. In the calibration process, the R2 values of the photodiode and SI 1145 with LI-190R were 0.609 and 0.961, respectively. Field validation data shows that SI 1145 had a strong correlation with LI-190R. In addition, the performance evaluation data shows the photodiode had a weaker correlation with LI-190R than SI 1145. In conclusion, the study successfully developed and designed affordable and reliable IoT-based PAR sensor monitoring systems, including a 3D-printed housing, hardware, programming, and IoT website. SI 1145 with a glass filter is an alternative sensor to monitor PAR at a low cost and has the advantage of being connected to IoT microcontrollers.