A comparative study on Al-Mg-Sc-Zr alloy fabricated by wire arc additive manufacturing with controlling interlayer temperature and continuous printing: Porosity, microstructure, and mechanical properties

Wire arc additive manufacturing (WAAM) technique is a promising approach to producing large-scale metal components due to high deposition efficiency and low production cost. However, fundamental research about WAAM-processed Al-Mg-Sc-Zr alloy was still fewer. In this study, Al-6.54Mg-0.36Sc-0.11Zr (wt%) components were successfully manufactured by WAAM with an interlayer temperature at 100 °C (named IW) and continuous printing (named CP), and the corresponding porosity, microstructure, and mechanical properties of components were studied in detail. The porosity of components as-deposited was relatively low, about 0.385 % and 0.116 %, respectively. The microstructures of the two components exhibited the same distribution characteristics in XZ and YZ planes: fine equiaxed grains (FEG) at remelted zone + FEG and coarse equiaxed grain (CEG) alternative distribution at middle zone + FEG at the top zone of the molten pool. The average grain size of component IW was about 10.51 ± 6.01 μm, and that of component CP significantly increased, to about 11.85 ± 5.86 μm. The short-circuit transition mode of cold metal transfer technology and the heterogeneous nucleation effect of primary Al3(Sc, Zr) and Al3(Sc, Zr, Ti) phases together promoted the formation of equiaxed grains and refined the microstructures. After heat treatment at 325 °C and 6 h, nano-Al3Sc precipitated with a size of about 15–50 nm. The yield strength (YS) of components IW and CP increased from 171 ± 3 MPa to 261 ± 1 MPa and 168 ± 7 MPa to 240 ± 17 MPa, respectively. Component IW had the highest ultimate tensile strength, about 400 ± 1 MPa. For WAAM-processed Al-Mg-Sc-Zr alloys, the contribution of the strengthening mechanism to YS was solid solution strengthening > precipitation strengthening > fine grain strengthening > dislocation strengthening.