The Effect of Fe on the Mechanical Properties of Stellite 6

Stellite 6 is a Co-based alloy with excellent wear and corrosion resistance, resulting in it frequently being used as a hard-facing material. The main defect that occurs in the hard-facing process is the peeling of the hard-facing layer, which is caused by thermal stress due to differences in thermal expansion coefficients. This peeling phenomenon can be prevented by using a material with an intermediate coefficient of thermal expansion as a buffer layer. Component surfaces are strengthened through a technique called hard-facing, which increases the components' resistance to wear. In order to increase the wear and corrosion resistance of metal components, a high-hardness substance is usually coated onto their surface. Grinding is carried out to smooth the surface after the material is welded onto the base component. Small pieces, also referred to as "scrap", are frequently produced during this surface machining procedure. In the hard-facing process, scrap containing a mixture of base material and Stellite 6 is generated during material processing. If this scrap can be used as a buffer layer, the cost of raw materials can be reduced through the recycling of resources, and the overall energy consumption for recycling can be reduced because the process of separating Stellite 6 from the scrap is eliminated. In this study, the physical properties of Stellite 6 with Fe added were explored to determine whether the scrap produced could be used as a buffer layer. When iron was added to the mixture, the amount of carbide decreased, in addition to the wear resistance and hardness decreasing. Regarding the thermal expansion coefficient, the thermal expansion coefficient of Stellite 6 was found to be 15.879 mu m/m center dot degrees C at 300 degrees C, and that of Stellite 6 with 40% Fe added was found to be 14.313 mu m /m center dot degrees C at 300 degrees C. The thermal expansion coefficient of carbon steel is reported to be 12.8 mu m /m center dot degrees C at 300 degrees C; thus, Stellite 6 with 40% Fe can be used as a buffer layer for Stellite 6 and carbon steel because of its suitable thermal expansion coefficient.