Solar Spectrum Reflectometer Measurements on Profiled and Small Samples: Design and Testing of Adapters

Testing solar reflective building materials is mainly performed in laboratories using Solar Spectrum Reflectometer (SSR) or spectrophotometry. To obtain aged materials values, after exposing materials in test farms for natural ageing or applying ASTM-D7897, treated samples shall be tested again using SSR. On-site measurements of new and aged surfaces is allowed using pyranometers or albedometers, which present issues caused both by high-pitched roof and by solar and sky requirements in several locations such as at southern and middle Europe latitudes, where clay tiles are a typical coverage of roof surfaces. The use of battery-powered SSR offsite could be a solution to obtain reliable measurements in every climate, lighting, and slope condition. However, the shape of roof surfaces remains an issue since most of the tiles are characterized by elaborated morphologies that cannot fit the measurement head of the SSR. In this study, two sets of cylindrical adapters for SSR, made via Fused Deposition Modeling and coated with solar reflective white diffuse paint or specular reflective coating were produced and tested to overcome this problem. The adapters were attached to the top of the measurement head and measurements were performed according to ASTM-C1549. These adapters were tested with samples characterized by ASTM-C1549, analyzing the output from all 6 detectors of SSR, and by spectrophotometry according to ASTM-E903, using both AM1GH and ASTM E891-87 irradiance spectra. Aluminum-coated adapters proved ideal due to non-impact on measurements. Solar reflectance showed strong linear correlation for 30–50 mm adapter lengths, indicating minimal signal damping. They will allow testing most of the samples that cannot be tested with standard methods, especially aged ones, without altering their surface.