Experimental Study on the Effect of High Temperature on the Physical and Mechanical Properties of Sandstone with Different Bedding Angles

As a typical sedimentary rock, the number of beddings in the horizontal direction of sandstone is far greater than that in the vertical direction, leading to its physical and mechanical properties showing obvious anisotropy with changes in bedding angle. After high temperature exposure, bedding damage further transforms the change rule of the physical and mechanical properties of sandstone with the bedding angle. This study tested the appearance, wave velocity, uniaxial compression, and conventional triaxial compression properties of sandstone with five bedding angles before and after high temperature exposure. The results show that (1) the longitudinal wave velocity, shear wave velocity, elastic modulus, and cohesion decreased, while the internal friction angle increased slightly. At the same temperature, when the dip angle of sandstone was 30 degrees or 60 degrees, the mechanical properties were optimal, and when the dip angle was 45 degrees, the mechanical properties were the worst. (2) High temperature increases the development degree of micropores and microfractures in the sandstone bedding plane and matrix, thus increasing the anisotropy degree of the physical and mechanical properties of sandstone with different bedding angles. (3) With increasing temperature, the rock samples gradually transitioned from brittle failure to ductile failure. Sandstone with a bedding angle of 0 degrees presented splitting failure that vertically penetrated the bedding plane at different temperatures. Sandstone with dip angles of 30 degrees and 40 degrees presented shear failure that penetrated the matrix and bedding plane. A failure plane along the bedding plane appeared at the end. Sandstone with dip angles of 60 degrees and 90 degrees was more prone to failure along the bedding plane, showing shear failure along the bedding plane and tensile failure along the bedding plane, respectively.