Improvement of Work-Hardening Behavior of Co-Cr-W-Ni Alloy by Adding Mn/Fe for Balloon-Expandable Stents

Key Engineering Materials(2023)

引用 0|浏览5
暂无评分
摘要
The Co-20Cr-15W-10Ni (CCWN, mass%) alloy, registered as American society of testing and materials (ASTM) F90, has been widely used as a balloon-expandable stent because of its excellent balance between its mechanical properties and corrosion resistance. To realize a less invasive stent placement, the stent diameter must be reduced, which implies that the stent strut thickness must be reduced. As such, the CCWN alloy must be high in strength and ductility while maintaining a low yield stress to facilitate the expansion and suppression of stent recoil. In this study, we focus on the effects of the adding Mn/Fe on the microstructure, mechanical properties, and corrosive properties of CCWN alloys. A 6 mass% Mn-added CCWN alloy with a grain size of approximately 20 μm prepared in this study exhibits excellent balance between tensile strength and ductility. In addition, it exhibits a lower yield stress while maintaining a high tensile strength compared with the ASTM F90 alloy. Meanwhile, a 6 mass% Fe-added CCWN alloy exhibits a higher ductility compared with the ASTM F90 alloy. The addition of Mn or Fe to the CCWN alloy increases the stacking fault energy of the alloy and suppresses strain-induced martensitic transformation during plastic deformation, thus improving the ductility of the alloy. Results of polarization tests show that the 6 mass% Mn-or Fe-added CCWN alloys exhibit the same corrosion current density as the ASTM F90 alloy. Mn-added Co-Cr-W-Ni alloys are suitable for use in balloon-expandable stents.
更多
查看译文
AI 理解论文
溯源树
样例
生成溯源树,研究论文发展脉络
Chat Paper
正在生成论文摘要