Basal osteotomy of the first metacarpal using patient-specific guides and instrumentation: biomechanical and 3D CT-based analysis

Introduction The aim of this study was to investigate the radiological outcomes of proximal closing metacarpal extension osteotomies using patient-specific guides and instruments (PSI) in early-stage trapeziometacarpal osteoarthritis to gain further insight into the joint loading surface and the benefits of the procedure. Methods In a prospective observational study, nine patients were included between 11/2020 and 12/2021, undergoing a total of ten proximal metacarpal extension osteotomies for basal thumb osteoarthritis. Computer-assisted surgical planning was performed using computed tomography (CT) and three-dimensional (3D) segmentation, allowing the fabrication of 3D-printed PSIs for surgical treatment. Inclusion criteria were a 1-year follow-up by CT to assess postoperative correction of the positional shift of the first metacarpal (MC1) and the location of peak loads compared with the preoperative situation. Results Radiographic analysis of the peak loading zone revealed a mean displacement on the articular surface of the trapezius of 0.4 mm ± 1.4 mm to radial and 0.1 mm ± 1.2 mm to palmar, and on the articular surface of the MC1 of 0.4 mm ± 1.4 mm to radial and 0.1 mm ± 1.2 mm to dorsal. Conclusion There were trends indicating that a flatter pressure distribution and a dorsal shift of the peak loading zone may contribute to an improvement in subjective pain and patient satisfaction associated with this surgical procedure. The non-significant radiological results and the minor dorsal-radial shifts in our small study group limit a firm conclusion. Level of evidence III.