Continuous Treatment of Refractory Wastewater from Research and Teaching Laboratories via Supercritical Water Oxidation-Experimental Results and Modeling

Teaching and research laboratories generate wastes of various compositions and volumes, ranging from diluted aqueous solutions to concentrated ones, which, due to milder self-regulation waste-management policies, are carelessly discarded, with little attention given to the consequences for the environment and human health. In this sense, the current study proposes the application of the supercritical water oxidation (SCWO) process for the treatment of complex refractory wastewater generated in research and teaching laboratories of universities. The SCWO, which uses water in conditions above its critical point (T > 647.1 K, p > 22.1 MPa), is regarded as an environmentally neutral process, uniquely adequate for the degradation of highly toxic and bio-refractory organic compounds. Initially, the wastewater samples were characterized via headspace gas chromatography coupled with mass spectrometry. Then, using a continuous tubular reactor, the selected operational parameters were optimized by a Taguchi L9 experimental design, aiming to maximize the total organic carbon reduction. Under optimized conditions-that is, temperature of 823.15 K, feed flow rate of 10 mL min(-1), oxidizing ratio of 1.5 (50% excess over the oxygen stoichiometric ratio), and sample concentration of 30%-TOC, COD, and BOD reductions of 99.9%. 91.5% and 99.2% were achieved, respectively. During the treatment process, only CO2, methane, and hydrogen were identified in the gaseous phase. Furthermore, the developed methodology was applied for the treatment of wastewater samples generated in another research laboratory and a TOC reduction of 99.5% was achieved, reinforcing the process's robustness. A thermodynamic analysis of SCWO treatment of laboratory wastewater under isothermal conditions was performed, using the Gibbs energy minimization methodology with the aid of the GAMS (R) 23.9.5. (General Algebraic Modeling System) software and the CONOPT 4 solver. Therefore, the results showed that SCWO could be efficiently applied for the treatment of wastewater generated by different teaching and research laboratories without the production of harmful gases and the addition of hazardous chemicals.