An injectable and 3D printable pro-chondrogenic hyaluronic acid and collagen type II composite hydrogel for the repair of articular cartilage defects

Current treatments for repairing articular cartilage defects are limited. However, pro-chondrogenic hydrogels formulated using articular cartilage matrix components (such as hyaluronic acid (HA) and collagen type II (Col II)), offer a potential solution if they could be injected into the defect via minimally invasive arthroscopic procedures, or used as bioinks to 3D print patient-specific customised regenerative scaffolds-potentially combined with cells. However, HA and Col II are difficult to incorporate into injectable/3D printable hydrogels due to poor physicochemical properties. This study aimed to overcome this by developing an articular cartilage matrix-inspired pro-chondrogenic hydrogel with improved physicochemical properties for both injectable and 3D printing (3DP) applications. To achieve this, HA was methacrylated to improve mechanical properties and mixed in a 1:1 ratio with Col I, a Col I/Col II blend or Col II. Col I possesses superior mechanical properties to Col II and so was hypothesised to enhance hydrogel mechanical properties. Rheological analysis showed that the pre-gels had viscoelastic and shear thinning properties. Subsequent physicochemical analysis of the crosslinked hydrogels showed that Col II inclusion resulted in a more swollen and softer polymer network, without affecting degradation time. While all hydrogels exhibited exemplary injectability, only the Col I-containing hydrogels had sufficient mechanical stability for 3DP applications. To facilitate 3DP of multi-layered scaffolds using methacrylated HA (MeHA)-Col I and MeHA-Col I/Col II, additional mechanical support in the form of a gelatin slurry support bath freeform reversible embedding of suspended hydrogels was utilised. Biological analysis revealed that Col II inclusion enhanced hydrogel-embedded MSC chondrogenesis, thus MeHA-Col II was selected as the optimal injectable hydrogel, and MeHA-Col I/Col II as the preferred bioink. In summary, this study demonstrates how tailoring biomaterial composition and physicochemical properties enables development of pro-chondrogenic hydrogels with potential for minimally invasive delivery to injured articular joints or 3DP of customised regenerative implants for cartilage repair.