Experimental Study and Finite Element Modelling of Squat Shear Walls under Combined Cyclic Loads and High Axial Loads

Experimental observations on three reinforced concrete shear walls with small shear span-to-depth ratio (SDR) under combined high vertical axial load and horizontal cyclic loads are presented. The influence of high axial load ratio (ALR) on the failure mode, hysteretic behaviour, displacement ductility, shear strength and stiffness of the squat shear walls is investigated. In addition, a novel built-in strain gauges measuring system is employed for measuring the strain conditions in the reinforcements during the whole test process. Test results indicate that high axial load restrains the development of cracks and improves the shear load capacity, but that it also decreases ductility and energy dissipation and aggravates stiffness degradation. Concrete crush and out-of-plane buckling were observed in all specimens, resulting in the final failure of the specimens. According to the strain analysis, the section of the squat walls coincided well with the assumption of plane section under the condition of high ALR. With the increase of ALR, the depth of the compression zone of members increases, while the length of plastic hinge decreases. When the axial load is relatively small, the vertical and horizontal reinforcements provided almost equal contribution to the shear capacity of squat shear walls. However, under extremely high axial load, both vertical and horizontal reinforcements cannot provide full contribution to the shear capacity. The hysteretic behaviours of the tested shear walls were simulated by a cyclic softened membrane model (CSMM). Simulation results indicate that CSMM captured well the nonlinear characteristics of the squat shear wall under high axial load.