Comparison of homemade mask designs based on calculated infection risk, using actual COVID-19 infection scenarios.

During pandemics such as COVID-19, shortages of approved respirators necessitate the use of alternative masks, including homemade designs. The effectiveness of the masks is often quantified in terms of the ability to filter particles. However, to formulate public policy the efficacy of the mask in reducing the risk of infection for a given population is considerably more useful than its filtration efficiency (FE). The effect of the mask on the infection profile is complicated to estimate as it depends strongly upon the behavior of the affected population. A recently introduced tool known as the dynamic-spread model is well suited for performing population-specific risk assessment. The dynamic-spread model was used to simulate the performance of a variety of mask designs (all used for source control only) in different COVID-19 scenarios. The efficacy of different masks was found to be highly scenario dependent. Switching from a cotton T-shirt of 8% FE to a 3-layer cotton-gauze-cotton mask of 44% FE resulted in a decrease in number of new infections of about 30% in the New York State scenario and 60% in the Harris County, Texas scenario. The results are valuable to policy makers for quantifying the impact upon the infection rate for different intervention strategies, e.g., investing resources to provide the community with higher-filtration masks.