Application of the observation simulator in the eXTP mission

n observation simulator is established for the Spectroscopy Focusing Array (SFA) and Polarimetry Focusing Array (PFA) onboard the planned enhanced X-ray Timing and Polarimetry observatory (eXTP). It consists of photon generation, imaging, detection, and event readout to generate data products, which can be analyzed by the standard astronomical analysis software. It is used to simulate a few astronomical sources to estimate and understand the impact of the payload and platform design configurations on the scientific goals of eXTP, including the background estimation of the central pixel in SFA, position dependence of silicon drift detector signals and its impacts, and pointing jitter requirements. The joint data analysis of the SFA and PFA payloads shows that the PFA image can help estimate the impact of nearby sources on the target source and select the proper pixels for the background estimation of the central pixel in SFA. The spectral and timing study of the millisecond pulsar depicts that the position dependence of silicon drift detector signals itself has an insignificant impact on the results. The type-C low-frequency quasi-periodic oscillations of black holes ranging from 0.01 Hz to 30 Hz are considered to raise the pointing jitter requirements of the telescope. In this case, the stability of the telescope should be less than 12 ^'' to avoid any spurious modulation signal. These examples demonstrate the necessity of an end-to-end observation simulator in the space mission, which will be further tested and improved by the ground segment in a wider range of applications.