Deep crustal structures with reverse time migration applied to offshore wide-angle seismic data: Equatorial and North-West Brazilian margins

We image the Moho discontinuity and deep crustal layers by applying the Reverse Time Migration (RTM) method to wide-angle seismic (WAS) data that were acquired along two different profiles in NW and SE offshore Brazil, where the spacing between OBS is 12.5 km and 150 m between shots. The application of this method is quite uncommon to ocean bottom seismometers (OBS) data due to the OBS wide spacing deployment and low folds. We analyze the effectiveness of the RTM method when applied to the reflectivity of the WAS data. We imaged the structures by cross-correlating the forward and backward wavefields given by the acoustic seismic equation. This allowed us to use each interface crossed by a ray as both a source and a receiver. The velocity models used to perform RTM were previously obtained by applying a procedure of two-dimensional forward ray-tracing fol-lowed by a damped least-squares travel time inversion. The results obtained have an unexpected large contri-bution from the wavefield traveling as refractions within the Earth and, because of that, we can talk about recovering refractors from the RTM results. We obtained strong and continuous refractors for depths of 7-15 km that correspond to the basement and the Moho discontinuity. As we move landwards, the refractors that correspond to the Moho discontinuity disappear due to the deepening of the surface. Finally, we investigate how the slight change on the velocity model influences the result of the RTM method. The obtained results are promising for a wide range of applications at a crustal scale seismic exploration, with wide-angle seismic data.