Emission characteristics of (halogenated) polycyclic aromatic hydrocarbons during printed circuit board combustion and estimated emission intensity of a typical e-waste dismantling site in South China.

The pollution of polycyclic aromatic hydrocarbons (PAHs) and halogenated PAHs (Cl/Br-PAHs) caused by electronic waste dismantling activities have attracted considerable attention. The present study investigated the emissions and formation of PAHs and Cl/Br-PAHs based on the combustion of printed circuit boards simulating electronic waste dismantling process. The emission factor of ΣPAHs was 648 ± 56 ng/g, which was much lower than that of ΣCl/Br-PAHs (8.80 × 104 ± 9.14 × 103 ng/g). From 25 to 600 °C, the emission rate of ΣPAHs reached a sub-peak of 7.39 ± 1.85 ng/(g•min) at 350 °C, then increased gradually with the fastest rate of 19.9 ± 21.8 ng/(g•min) at 600 °C, whereas that of ΣCl/Br-PAHs was the fastest at 350 °C with a rate of 597 ± 106 ng/(g•min), then decreased gradually. The present study suggested that the formation pathways of PAHs and Cl/Br-PAHs are by de novo synthesis. Low molecular weight PAHs were readily partitioned into gas and particle phases, whereas high molecular weight fused PAHs were only detected in oil phase. However, the proportion of Cl/Br-PAHs in particle and oil phases were different from that of gas phase, whereas similar to that of the total emission. In addition, PAH and Cl/Br-PAH emission factors were used to estimate the emission intensity of pyrometallurgy project in Guiyu Circular Economy Industrial Park, and it was shown that approximately 1.30 kg PAHs and 176 kg Cl/Br-PAHs would be emitted annually. This study revealed that Cl/Br-PAHs would be formed by de novo synthesis, and for the first time provided the emission factors of Cl/Br-PAHs during the heat treatment process of printed circuit board, as well as estimated the contribution of pyrometallurgy, a new electronic waste recovery technology, to environmental Cl/Br-PAH pollution, which provides potential scientific information for governmental decision-making on the control of Cl/Br-PAHs.