A quantitative analysis of optimum design for rigid ankle foot orthoses: The effect of thickness and reinforcement design on stiffness

Background:An ankle foot orthosis (AFO) which is prescribed to be rigid should only deform a small amount to achieve its clinical goals. Material thickness and the design of reinforcing features can significantly affect AFO rigidity, but their selection remains based on anecdotal evidence.Objectives:To quantify the effect of these parameters on AFO stiffness and to set the basis for quantitative guidelines for the design optimisation of rigid AFOs.Study design:Experimental and computational study.Methods:A polypropylene AFO was produced according to UK standard practice and its stiffness was experimentally measured for 30Nm of dorsiflexion. Its geometry and mechanical characteristics were utilised to create a finite element (FE) model of a typical AFO prescribed to be rigid. Following validation, the model was used to quantify the effect of material thickness and reinforcement design (i.e., reinforcement placement, length) on stiffness. A final set of AFO samples was produced to experimentally confirm key findings.Results and conclusions:For a specific AFO geometry and loading magnitude, there is a thickness threshold below which the AFO cannot effectively resist flexion and buckles. FE modelling showed that stiffness is maximised when reinforcements are placed at the anterior-most position possible. This key finding was also experimentally confirmed. The stiffness of an AFO reinforced according to standard practice with lateral and medial ribbing was 4.4 +/- 0.1 Nm/degree. Instructing the orthotic technician to move the ribbings anteriorly increased stiffness by 22%. Further stiffening is achieved by ensuring the reinforcements extend from the footplate to at least two-thirds of the AFO's total height.