Deformation Measurement and Simulation of Ti-6Al-4V Blades Induced by Shot Peening Process

Research Square (Research Square)(2022)

引用 0|浏览0
暂无评分
摘要
Abstract The shape and deformation of the blades play important roles in the aerodynamic performance of aeroengines, which results from the plastic deformation and the residual stresses after complex manufacturing processes, especially the shot peening. However, few studies were focused on the detailed strategies of the shot peening on the complex profile and the superposition effects of residual stresses during the entire manufacturing processes. In this paper, based on the concept of eigenstrains, we investigated the effect of shot peening on the residual stress and deformation of the blade by combining the experimental measurement and the local-global simulation. The results show that the initial residual stresses induced by the previous milling process could be neglected. After the shot peening, the blade has the largest deformation amount if considering the initial residual stresses during milling with large scale material removal, when compared with no initial residual stresses and initial residual stresses after dynamic milling of blades. Furthermore, the In-out sequence of shot peening results in the smallest deformation, and the pre-deformation of the blade can effectively offset this deformation. Finally, the shot peening strength should not be too high in practical blade manufacturing when the thickness is too thin, which may be a great threat to the reliability and safety of blades.
更多
查看译文
关键词
shot peening process
AI 理解论文
溯源树
样例
生成溯源树,研究论文发展脉络
Chat Paper
正在生成论文摘要