Numerical investigation on heat transfer enhancement of spray cooling by surface structure optimization

A numerical model of spray cooling for enhanced surfaces in the non-boiling regime is created with deionized water as cooling medium. This model is validated by contrasting the simulated data with the corresponding experimental data, and the relative deviation is within 12 %. Compared with a smooth surface, the area of the enhanced surface is expanded, the cooling performance is significantly improved, but the surface temperature distribution is less uniform. Compared to the straight groove surface with the same area, the heat flux of the radial groove surface is higher because its surface structure is more conducive to the spreading and leaving of the liquid film. Studies of the effects of the structure parameters (groove width and groove number) of the radial groove surface on the heat transfer show that there is an optimal groove width (0.2 mm) and groove number (45) for the strongest cooling capacity, and both the velocity and thickness of the liquid film are significant factors in cooling performance. The faster the liquid film velocity, the thinner the liquid film and, thus, the better the heat transfer. Motivated by these findings, three novel enhanced surfaces are machined to increase liquid film fluidity and heat transfer area even further. The cooling performance of the three novel enhanced surfaces is further improved, and the slope groove surface acquires the strongest cooling capacity due to the acceleration of liquid film flow by gravity, although its heat transfer area is not the largest. Research on all enhanced surfaces indicates that thinner liquid film and faster liquid film flow should be the primary design goals of the enhanced surface, followed by an increase in heat transfer area.